Complete kit to connect a commercial or office coffee machine to water supply. Plumbed espresso machines need great quality filtered water to remove limescale and small particles from the water. If limescale and small particles are not removed from the water, these are likely to cause damage to and/or block the valves, jets, and restrictors contained within your coffee machine.
Everpure are the industry standard in coffee machine filtration. This kit uses an Everpure QL3B filterhead to allow connection of the appropriate Everpure water filter.
This kit also includes a pressure reduction/limiting valve to ensure the coffee machine operates correctly and is not damaged by excess water inlet pressure. Also included is an isolation valve for easy filter replacement and isolation of the machine water supply. Kit is pressure tested and ready to install.
Once the plumbing kit is installed the filter is easily connected and disconnected for quick and easy replacement.
To install the filter, turn the isolating tap to closed position, rotate the shutoff lever anti-clockwise, insert the filter into the base of head and rotate it clockwise, rotate the shutoff lever clockwise, the turn the isolating valve to open to activate water flow.
To remove an old filter, turn the isolating tap to closed position, rotate the shutoff lever anti-clockwise, rotate the used filter anti-clockwise to unlock it, then pull the filter down to remove it from the head.
Water filter and connection hoses sold separately.
Filters should be replaced every 6 months.
NOTE: This kit comes as individual components and requires assembly.
- Pressure reduction valve to prevent excess mains water from damaging the coffee machine
- Isolating tap for easy isolating of water supply
- Includes mounting bracket and screws
- Inlet: 1/2" BSP (15mm) Male
- Outlet 3/8" BSP Male
- Capacity: dependent on the filter installed